WWW.MAUSERSHOOTER.COM
Everything to turn your old Mauser into a fine hunting rifle.
brought to you by Wicks Trading Post
| Click
Here for Crankyfarmer
Home |
|
|
|
|
 ATI
Mauser Stock with built in scope mount
Mauser 98 Stock with built-in scope mount rail. Replace the old wood with an extremely durable stock made of black, glass-filled nylon. No gunsmithing or modifications required. Built-in scope mount allows multiple positions for rifle scopes. Sling swivel studs. Rubber butt pad. Fits barrel diameter .950 to .990". Fits 7mm/8mm, Large-ring,
standard Bent-bolt, Mauser 98s. Partial list includes German K-98s,
Czech VZ-24s, Yugo 24/47s, Yugo 48/48As, Turkish 1903/1937/1938/1946s,
etc... Will NOT fit Large-Ring Swedish M38/M96 6.5x55 or Small-Ring
Mausers (Spanish M1916 .308). Must CONVERT BOLT to fit straight bolt or
"wide-arc" bolt. Straight bolt
or “wide-arc” bolt Mausers will need bolt bent or replaced.
 $85.00 |
 Mauser Corelite
Stocks
F-34 Designation is for sporter barrels. F-54 Designation is for varmint barrels. Mauser
98 F34 Black........................................#429-533
$65.00
Mauser
98 F54 Black.........................................#321-565
$65.00
|
Corelite Series III Mauser Stock
The Mauser stock from CoreLite Precision may be the most convenient stock ever made for gunsmiths sporterizing surplus and commercial Mauser rifle actions! The stock is available for two different barrel channels—F34 or F54. These barrel channels make the stock a drop-in fit with pre-threaded Adams & Bennett barrels in those contours. There's no barrel channel inletting required. Just drop your barreled action into the stock, tighten the receiver's screws, and go to the range! Fajen pioneered the development of stocks that were keyed for a drop-in fit with pre-threaded, short chambered barrels—CoreLite has pioneered the same concept in synthetic stocks! Available in Black Synthetic. Note: If the original bolt handle has been bent down or replaced, it wil be necessary to "rasp-in" a bolt handle notch in the stock. Drop-in construction when using Adams & Bennett barrels (requires rasping in the bolt handle notch) Available in Sporter (F34) & Varminter (F54) barrel channels Fits most large ring Mauser rifles Completely weatherproof Front & rear swivel studs Non-slip rubber buttpad Weighs just 28 ounces |
 303 Enfield No1 Scope Mount
Fits .303 No.1, Mk. 3 (Does not
fit .308) This .303 Enfield scope mount is extremely stable and will
hold zero. Black, T-6 aluminum. Great hunting rifle. Install using
weaver-type rings. No gunsmithing.
$42.00 |
 .303 Enfield No4 Scope Mount
Fits .303 No. 4, Mk. 1, 2, & 5. This .303 Enfield scope mount is
extremely stable and will hold zero. Black, T-6 aluminum. Great hunting
rifle. Install using weaver-type rings. No gunsmithing. $42.00
|
 Mauser Bolt Handle
Converts straight bolt or “wide-arc” bolt to bent bolt handle to
allow use of a scope. Fits all Mausers. Includes drill, tap, hardware
and installation instructions. Made of stainless steel in the USA. $14.49
#MBH1800 |
|
|
|||||||||
